Upgrade your Club Car IQ Regen with the Curtis 1510/1515 440 Amp 10-Spline High Speed Motor and Controller Kit, designed to deliver improved acceleration, higher top speeds, and smooth, efficient power delivery. This setup pairs a reliable 440-amp Curtis controller with a durable high-speed 10-spline motor and 48v solenoid for consistent performance and enhanced drivability.
Motor Features:
Club Car 48 volt DS IQ, Power Drive Plus, Precedent, Onward and Tempo high speed motor (Not a replacement for Series Motors)
10-spline coupler
Includes a speed sensor/ magnet
1-year warranty
With upgraded controller:
Speeds up to 24 mph at 48 volts
20-25% torque increase
9 HP peak at 48 volts
Controller Features:
TSX 3.0 440AMP 36-48V Bluetooth Controller
Cost effective improvement to increase the speed and power of a golf car
The Navitas app allows you to monitor the vehicle's performance
Built-in speedometer
Gear indicator (Forward, Neutral, Reverse)
One-click Car Lock Out feature
Live battery voltage monitoring
Provides alerts that you can send directly to your technician/dealer by email
New "Cruise mode" for higher top speed (Up to 15% faster)
Speeds up to 23 mph with stock 18" tires
Up to 75% more raw power than a stock controller. Improved hill climb capability with 22/23" tires
Use your stock motor, solenoid and existing wiring
Plug and play installation
Use the "lock out feature" to lock in settings to control power and speed
Reliance Club Car IQ Regen 10-Spline High Speed Motor - 25-512
New Motor Break-In Instructions:
Follow these steps carefully:
1. Initial Drive: Drive the vehicle for 8–10 miles at varying speeds, taking care to accelerate gently during this period.
2. Temperature Monitoring:
Drive on a level surface, such as pavement or asphalt. Gradually accelerate and maintain full speed for 5–10 minutes. Then, stop and check the motor temperature.
During the first 30 minutes of use, check the motor temperature every 10 minutes. To do this, touch the center section of the motor near the aluminum end bell (silver component).
If the aluminum end bell is too hot to touch, stop using the motor and allow it to cool down.
If you can hold your hand on the motor for more than 5 seconds, it is safe to continue driving for a few more miles before rechecking the temperature. Repeat steps 1 and 2 until the 8-10 mile break-in period is completed and the motor operates at a cooler temperature. Following this process will help ensure your electric motor is properly conditioned for long-term use.
CAUTION: Exercise caution while checking the motor. Avoid touching any exposed electrical connections while the power is on.
25-612 Kit, CC IQ Regen 1510/1515 High Speed Motor+Navitas 440A