Take your golf cart to the next level with the Club Car Series 36/48V 600 Amp 10-Spline High Speed Motor and Controller Kit. Delivering extreme power and acceleration, this high-performance combo pairs a robust 600-amp controller with a high-speed motor for increased torque, faster top speeds, and smooth, reliable operation. A 48V solenoid is also included, providing dependable power engagement and making installation more convenient.

Motor Features:

• Club Car Series 36/48 volt high speed motor (not a replacement for Sepex/Shunt motors)
• 10-spline coupler
• Does not include a speed sensor/motor magnet
• Includes a 1-year warranty
• With upgraded controller:
  • Speeds up to 22 mph at 48 volts
  • 20-25% torque increase
  • 10.0 HP peak at 48 Volts

Controller Features:

• Adjust the Top Speed, Acceleration and Regenerative Braking on-the-fly
• Ultimate Range
• Easy Plug and Play installation
• Built-in Protection to prevent motor burn-out

Kit Includes:

• Navitas TSX3.0 600A 36-48V DC Controller - 25-025
• Club Car Series TSX Harness - 31930
• Bolt 48V HD Solenoid (36V Compatible) - 33-001
• Reliance Club Car Series 10-Spline High Speed Motor - 25-511

New Motor Break-In Instructions:

Follow these steps carefully:

• 1. Initial Drive: Drive the vehicle for 8–10 miles at varying speeds, taking care to accelerate gently during this period.
• 2. Temperature Monitoring:
  • Drive on a level surface, such as pavement or asphalt. Gradually accelerate and maintain full speed for 5–10 minutes. Then, stop and check the motor temperature.
  • During the first 30 minutes of use, check the motor temperature every 10 minutes. To do this, touch the center section of the motor near the aluminum end bell (silver component).
  • If the aluminum end bell is too hot to touch, stop using the motor and allow it to cool down.
  • If you can hold your hand on the motor for more than 5 seconds, it is safe to continue driving for a few more miles before rechecking the temperature. Repeat steps 1 and 2 until the 8-10 mile break-in period is completed and the motor operates at a cooler temperature. Following this process will help ensure your electric motor is properly conditioned for long-term use.
• CAUTION: Exercise caution while checking the motor. Avoid touching any exposed electrical connections while the power is on.