Upgrade your performance with the Club Car Series 36/48V 440 Amp 10-Spline High Speed Motor and Controller Kit, engineered for drivers who demand faster acceleration and increased top speed. This high-output system pairs a powerful 440-amp controller with a precision built 10-spline high-speed motor, delivering enhanced torque, smoother power delivery, and improved efficiency on both 36V and 48V setups.

Motor Features:

• Club Car Series 36/48 volt high speed motor (not a replacement for Sepex/Shunt motors)
• 10-spline coupler
• Does not include a speed sensor/motor magnet
• Includes a 1-year warranty
• With upgraded controller:
  • Speeds up to 22 mph at 48 volts
  • 20-25% torque increase
  • 10.0 HP peak at 48 Volts

Controller Features:

• TSX 3.0 440AMP 36-48V Bluetooth Controller
• The Navitas app allows you to monitor the vehicle's performance
  • Built-in speedometer
  • Gear indicator (Forward, Neutral, Reverse)
  • One-click Car Lock Out feature
  • Live battery voltage monitoring
  • Provides alerts that you can send directly to your technician/dealer by email
• New "Cruise mode" for higher top speed (Up to 15% faster)
  • Speeds up to 23 mph with stock 18" tires
• Up to 75% more raw power than a stock controller. Improved hill climb capability with 22/23" tires
• Use your stock motor, solenoid and existing wiring
• Control your regen braking in forward and reverse for added safety when driving or backing down inclines
• Use the "lock out feature" to lock in settings to control power and speed

Kit Includes:

• Navitas TSX3.0 600A 36-48V DC Controller - 25-047
• Club Car Series TSX Harness - 31930
• Bolt 48V HD Solenoid (36V Compatible) - 33-001
• Reliance Club Car Series 10-Spline High Speed Motor - 25-511

New Motor Break-In Instructions:

Follow these steps carefully:

• 1. Initial Drive: Drive the vehicle for 8–10 miles at varying speeds, taking care to accelerate gently during this period.
• 2. Temperature Monitoring:
  • Drive on a level surface, such as pavement or asphalt. Gradually accelerate and maintain full speed for 5–10 minutes. Then, stop and check the motor temperature.
  • During the first 30 minutes of use, check the motor temperature every 10 minutes. To do this, touch the center section of the motor near the aluminum end bell (silver component).
  • If the aluminum end bell is too hot to touch, stop using the motor and allow it to cool down.
  • If you can hold your hand on the motor for more than 5 seconds, it is safe to continue driving for a few more miles before rechecking the temperature. Repeat steps 1 and 2 until the 8-10 mile break-in period is completed and the motor operates at a cooler temperature. Following this process will help ensure your electric motor is properly conditioned for long-term use.
• CAUTION: Exercise caution while checking the motor. Avoid touching any exposed electrical connections while the power is on.