The golf cart speed switch or board is one of the most vital parts of the whole caddie. It sends a signal to your controller communicating the position of the throttle, or if you have an older cart, it's sending a lot more than that. The vintage drive systems used this part to send all of the energy from the batteries to their next destination. As you can imagine, this was a lot of stress on the stationary and the EZGO Moveable Contact. These parts are made out of copper. While it is praised for its low cost and high conductivity, it melts at a pretty low temperature compared to other metals. You are more than likely going to replace this several times over the coach's life.

This golf cart contact is not a difficult part to install. We do recommend that you get an EZGO OEM service manual to walk you through the process. You would hate to miss a small step, and nothing works properly. Call today, and an expert at Buggies Unlimited will be happy to help.

Specifications:

• Movable copper wiper contact, with spring, heat resistant insulated plastic housing, lead insulation, and eyelet terminal
• Fits 1982-1993 EZGO electric models with resistor type systems
• Measurements: 12 1/2" in length 1/4" W
• Replaces OEM Number(s): 17504-G2